Rolling Pin NECRONIC

Before use, thoroughly knead the material following the manufacturer’s guidelines. For best results, level the surface with a smooth roller first. Then slowly roll the textured tool over the surface, applying even pressure throughout. Depending on the material, it may be necessary to moisten the roller to prevent sticking. Once the compound has set, remove any excess to enhance detailing.

This roller is compatible with a wide range of materials such as polymer clays (Fimo, Super Sculpey), epoxy putties (Green Stuff, Milliput), and air-dry clays. Polymer clay can be textured directly on MDF bases and baked at 150°C for 15 minutes. For sticky materials like Green Stuff, use water, talcum powder, or modeling vaseline to reduce adherence. Milliput can be mixed with children’s modeling clay (50/50 ratio) for improved handling. Always clean the roller after use with water and a fine brush. Not suitable for unsupervised use by minors.