Rolling Pin Norsemen

Before use, knead your clay or putty thoroughly until it reaches a uniform consistency. Spread the material over a flat surface, smoothing it with a plain roller beforehand. Depending on the material, lightly moisten the roller to prevent sticking. Roll slowly and apply even pressure across the surface to achieve a consistent texture. Let the material cure or bake before trimming any excess.

This roller is compatible with polymer clays like Fimo or Super Sculpey and can also be used with epoxy putties such as Milliput and Green Stuff. For base creation, MDF boards are recommended, as they can be baked with polymer clay at 150°C for 15 minutes without damage. Green Stuff may require water or talcum powder to reduce stickiness. Milliput works well when blended 50/50 with children's modeling clay for better pliability. After use, clean the roller thoroughly with water and a soft brush to preserve fine details. Not suitable for unsupervised use by children.